Now place the cooling system back on top of processor and clip
it in place.
Next plug fan back into motherboard, and replace the fan.
Screw it in from the rear.
Now insert hard drive and floppy drive cables into
motherboard.
Feed cable through system, so that it is nice and tidy.
(Sometimes these cables are already fed and fitted)
Next insert cables into CD-ROM, floppy drive and hard drive
along with their power connector.
Now replace cradle and screw it into place. Check that drives
are aligned correctly to the front of the case.
Finally put sides and lid of case on, and screw in any extras
(Example below shows the wireless network cable being attached).
NOW YOUR SYSTEM IS BUILT, IT IS TIME
TO TEST IT. AT THIS TIME DO NOT CLOSE UP THE SYSTEM, AS YOU MAY NEED TO MAKE
ADJUSTMENTS (ITS ALSO BAD LUCK). SO CONNECT UP YOUR KEYBOARD, MOUSE AND MONITOR, AND PLUG INTO YOUR
POWER SUPPLY OR EXTENSION CABLE. THE TIME HAS NOW COME TO SEE IF ALL YOUR HARD
WORK HAS PAID OFF.
